Vivotek IP7161 - Page 155

VIVOTEK
User's Manual - 155
Syntax:
http://<servername>/cgi-bin/admin/ipfilter.cgi?
method=<value>&[start=<ipaddress>&end=<ipaddress>][&index=<value>]
[&return=<return page>]
PARAMETER VALUE DESCRIPTION
addallow Add a set of allow IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
adddeny Add a set of deny IP address range to server. Start and end
parameters must be specified. If the index parameter is
specified, it will try to add starting from index position.
deleteallow Remove a set of allow IP address range from server. If start
and end parameters are specified, it will try to remove the
matched IP address. If index is specified, it will try to remove
the address from given index position. [start, end] parameters
have higher priority then the [index] parameter.
Method
deletedeny Remove a set of deny IP address range from server. If start
and end parameters are specified, it will try to remove the
matched IP address. If index is specified, it will try to remove
the address from given index position. [start, end] parameters
have higher priority then the [index] parameter.
start <ip address> The start IP address to add or to delete.
end <ip address> The end IP address to add or to delete.
index <value> The start position to add or to delete.
return <return page> Redirect to the page <return page> after the parameter is
assigned. The <return page> can be a full URL path or relative
path according to the current path. If you omit this parameter,
it will redirect to an empty page.
UART HTTP tunnel channel (capability.nuart>0)
Note: This request requires operator privilege
Method: GET and POST