What to do if Vivotek Security Camera system problems remain after reset?
If you continue to experience system problems with your Vivotek Security Camera even after performing a reset, try restoring the factory settings and then reinstalling the camera.
General| Maximum resolution | 640 x 480 pixels |
|---|---|
| Focal length range | 2 - 4 mm |
| Sensor type | CMOS |
| Optical sensor size | 1/4 \ |
| Built-in microphone | No |
| Flash memory | 4 MB |
| Internal memory | 32 MB |
| Supported network protocols | TCP/IP, HTTP, UPnP, RTSP/RTP/RTCP, IGMP, SMTP, FTP, Telnet, DHCP, NTP, DNS, DDNS |
| Dimensions (WxDxH) | 96.2 x 126.4 x 47.4 mm |
| Compatible operating systems | Microsoft Windows 2000, XP. |
| Compliance industry standards | 802.3af |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
Weight and Dimensions| Weight | 276 g |
|---|
Details physical setup and initial connection of the camera.
Describes using the installation wizard from the product CD.
Verifying network configuration like IP, subnet mask, gateway, and DNS.
Setting up administrator and user passwords for security.
Process of logging in with username and password.
Steps for installing browser plug-in for camera access.
Describes the layout of the camera's main interface.
How to use the digital zoom feature.
How to capture still images from the camera.
Configuring client-side media and protocol options.
Optimizing video quality and bandwidth through settings.
Creating user accounts for access control.
Setting up motion detection for security purposes.
Procedure for updating the camera's firmware.
Explanation of system settings like date, time, and LED indicators.
Managing user accounts and passwords.
Configuring LAN/PPPoE, IP address, subnet, DNS, etc.
Controlling client access via IP address filtering.
Adjusting video size, quality, frame rate, and orientation.
Configuring audio input source, codec, and bit rate.
Setting up email notifications for snapshots/logs.
Configuring FTP for snapshot uploads.
Setting up motion detection windows and sensitivity.
Configuring snapshot schedules, triggers, and naming conventions.
Configuring video clip recording schedules and triggers.
Configuring digital output triggers based on events.
Restarting the network camera.
Restoring the camera to its original factory settings.
Procedure for updating the camera's firmware.
Information on LED status and system reset/restore procedures.
Using URLs to control camera functions and retrieve data.
To Next Page
