Vivotek IP8337H-C - Page 196

VIVOTEK
196 - User's Manual
8.16 Open Anystream
Note: This request requires Viewer access privileges.
Syntax:
For HTTP push server (MJPEG):
http://<servername>/videoany.mjpg?codectype=mjpeg[&resolution=<value>&mjpeg_quant=<value
>&mjpeg_qvalue=<value>&mjpeg_maxframe=<value>]
For RTSP (MPEG4), the user needs to input the URL below into an RTSP compatible player.
rtsp://<servername>/liveany.sdp?codectype=mpeg4[&resolution=<value>&mpeg4_intraperiod=<val
ue>&mpeg4_ratecontrolmode=<value>&mpeg4_quant=<value>&mpeg4_qvalue=<value>&mpeg4
_bitrate=<value>&mpeg4_maxframe=<value>]
For RTSP (H264), the user needs to input the URL below into an RTSP compatible player.
rtsp://<servername>/liveany.sdp?codectype=h264[&resolution=<value>&h264_intraperiod=<value
>& h264_ratecontrolmode=<value>& h264_quant=<value>& h264_qvalue=<value>&
h264_bitrate=<value>& h264_maxframe=<value>]
<product dependent>
PARAMETER VALUE DEFAULT DESCRIPTION
codectype mjpeg, mpeg4, h264
<product dependent>
N/A Set codec type for Anystream.
solution capability_videoin_resolution <product
dependent>
Video resolution in pixels.
mjpeg_quant 0, 1~5
99, 1~5
<product dependent>
3 Quality of JPEG video.
0,99 is the customized manual
input setting.
1 = worst quality, 5 = best
quality.
<product dependent>
mjpeg_qvalue 10~200
2~97
<product dependent>
50
<product
dependent>
Manual video quality level
input.
(This must be present if
mjpeg_quant is equal to 0, 99)
<product dependent>
mjpeg_maxframe 1~25,
26~30 (only for NTSC or
15 Set maximum frame rate in fps
(for JPEG).