Vivotek IP8362 - Page 84

VIVOTEK
84 - User's Manual
Custom command
If
Custom Camera (scanner)
is selected as the PTZ driver, the
Preset Position
and
PTZ Control
Panel
on the main page will be disabled. You will need to congure command buttons to control the PTZ
scanner. Click
Custom Command
to open the Custom Command page to set the commands in the
Control Settings session. Please refer to your PTZ scanner user's manual to enter the commands in the
following elds. Click
Save
to enable the settings and click
Close
to exit the page.
NOTE
►If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D protocol as the PTZ driver, the
Control Settings column will not be displayed.
►For all PTZ drivers, a total of ve additional command buttons can be congured.
►The command buttons will be displayed on the main page:
2010/12/10 17:08:56