4
Selecting a Channel Source
Select the source of your television signal: either
Antenna(Over-the-air) or Cable (Out-of-the-wall).
1. On the remote control, press INPUT and use the Arrow
buttons to highlight TV (antenna icon), then press OK.
2. Press the MENU button, select Channels and press OK. Th e
CHANNELS menu is displayed.
3. On the CHANNELS menu, highlight Channel Source and
using the Left/Right Arrow buttons to select either Antenna
or Cable.
Finding Channels
The TV may need to scan for channels before it can display
programs and their associated information. A channel scan is
required for free over-the-air channels (using an antenna) and
cable channels from an out-of-the-wall connection (without a
cable box). Moving the TV to an area with different channels
requires the TV to scan for channels again.
To perform an Auto Channel Scan:
1. From the CHANNELS menu,
highlight Find Channels, and
press OK. The channel scan
begins.
2. Wait until the channel scan is
100% complete. Highlight Done
and press OK.
3. Press the EXIT button on the
remote.
If the channel scan is cancelled,
the channels that were already
discovered are retained. A new
channel scan will clear all channels.
FIND CHANNELS
Channels Found
Digital: 0
Analog: 0
13% Complete
Cancel
Cancel the channel scan.
SETTING UP THE TUNER
You can use the TV’s Tuner menu to:
• Select a channel source
• Find channels
• Perform a partial channel scan
• Manually add channels
• Select channels to skip
• Select the language for
the audio from analog and
digital channels.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
