ENG - 10
7
Remove the battery cover by gently
sliding it away from the remote.
8
Insert the included batteries and gently
slide the battery cover back into place.
9
After turning on both your TV and sound bar, it will automatically begin searching for an active input.
*
The LED indicator on the front of the sound bar will begin cycling in different colors through inputs
until an audio source is detected.
**
Y o u
c a n
press
the
INPUT button to switch between audio sources. For example,
if you connected your TV to HDMI (ARC), set the sound bar to
HDMI-ARC.
To p To p
Input Power
*Occurs only during rst-time set up.
**Auto detect function only occurs once when the sound bar is rst powered on. To enable this feature
again, you must do a Factory Reset (see the Using Button Combinations on page 18 for more
information) or press and hold the INPUT button for 3 seconds.
When needed, VIZIO recommends replacing the batteries that came
with this remote with two, new Duracell ‘AAA’ alkaline batteries.
First-time Setup
Tip: Pressing the INPUT button will stop the auto
detect function.
Mute
Mute/unmute.
(Long press to turn LED power indicator on/o)
To Next Page
Loading...
Need help?
General
