R750EU5 - IE3 - TE4 - IE4 - ISE4
English 30 Ed.8 / 10-2012
GB
START-UP
- Engines on pallets
Remove the covers and protective
elements applied to the engine open-
ings (for instance, air suction ducts
or turbocharger air inlet, exhaust gas
ducts or turbocharger guard).
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative xing clips; if
they are damaged, replace them.
All surfaces and components pro-
tected with “FL MECAFLUID / P118 V”
protective oil can be cleaned with a
suitable solvent.
Check the level of the uids: engine oil
and coolant. Top up if necessary.
- Engines on vehicles
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts.
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative xing clips; if
they are damaged, replace them.
All surfaces and components pro-
tected with “FL MECAFLUID / P118 V”
protective oil can be cleaned with a
suitable solvent.
Check the level of the uids: engine oil
and coolant. Top up if necessary.
Nothing needs to be done to remove the
internal protection (either for engines on
pallets or on vehicles).
To Next Page
Loading...
Need help?
General