R750EU5 - IE3 - TE4 - IE4 - ISE4
English 55 Ed.8 / 10-2012
GB
FUEL FILTER REPLACEMENT
Fuel Filter (Z)
Follow the procedure below.
1- Turn off the engine and remove the
ignition key.
2- Let the engine cool down adequately to
avoid being burnt.
3- Prepare a container to collect any leak.
4- Disassemble lter(Z) and replace it.
5- Fill the new lter with fuel from the lter
you have just removed.
6- Lubricate the gasket of the new lter
before mounting it.
7-Ret the lter.
8- Bleed air from the fuel supply circuit.
(See “Fuel supply circuit bleeding”)
9- Turn the engine on and check for any
fuel leaks.
If any fuel leaks are found, stop the
engine immediately and contact an
authorised service centre.
Do not throw away any polluting
material in the environment. Carry out
their disposal in compliance with the
relevant legislation in force.
To Next Page
Loading...
Need help?
General