Removing System Logs from the Edge
VeloCloud is in the process of creating a tool that you can
run immediately after the hard reset (the hard reset is
described in the above section) that will enable you to
remove all the persistent system logs and unused data
partitions to ensure that the Edge is in a factory-shipped
state. These instructions will be updated once the tool is
available.
Testing the VeloCloud Edge
Follow the steps below to test the Edge.
1. Open an Internet browser and go to http://192.168.2.1
The VeloCloud Edge Activation screen displays as
shown in the image below.
2. Click the Review the Configuration link in the
VeloCloud Edge Activation screen.
To Next Page
Loading...