VoiceAlert User Manual
2.6.2 Setting the trigger indicator LED
Once you have finished programming / installing the Sensors, it is
recommended that the trigger indicator LED be turned off using switch
SW1 (Figure 4). This will also extend Sensor battery life.
2.6.3 Setting the Optic PIR on/off
If you flick switch SW 2 (Figure 8) to the left, then the PIR optic for that
Sensor will be off and only the external trigger connector block (J1) will be
operational. If SW 2 is flicked to the right then both the PIR optic and the
J1 external device connector will be active. Consult your WirelessAlert
Agent if you are interested in using External Devices to trigger the sensor
via the J1 connector block or how to make use of m-TX module to perform
the same function.
2.7 Positioning the Base Receiver
Suitable areas for positioning the Base Receiver include the main bedroom
or somewhere more central like the living area. Adjust the volume on the
Base Receiver to a level that is loud enough to hear whilst moving around
the interior of the house. Make use of a UPS or several power supply units
at different locations to make it easy to move VoiceAlert from one location
to the next. Make sure not to leave the Base Receiver lying around in a
vulnerable location where untrained fingers can get hold of it and
inadvertently reset or change settings on the unit.
3 VoiceAlert Advanced Operation
You may have noticed that there are four Relay and one Audio Outputs
present at the back of the Base Receiver (remove the small cover at the
back of unit to expose the Relays).
The use of the Relays and Audio Output requires a degree of electrical
wiring knowledge. If you are familiar with electronics and wiring of electrical
devices then you may want to make use of the Relays to control security
lights and or a siren. The audio output can be used to extend the audible
range of the VoiceAlert to other parts of your home using external desktop
speakers and or your home PA system. Please contact your WirelessAlert
agent for assistance if need be.
If you are interested in connecting external sirens and or security lighting to
your VoiceAlert but you do not have experience with electronics and wiring
of external device then please contact your WirelessAlert agent and they
will be able to assist you in this regard or refer you to a qualified
WirelessAlert technician.
Your WirelessAlert Agent will also be able to assist with multiple Sensor
installations on large properties. Large properties often require Sensors
placed a fair distance from the Base Receiver (often beyond the transmit
capabilities of a Sensor). It is extremely important to ensure that radio
signals from Sensors placed far away or behind potential radio impeding
objects still reach the Base Receiver with sufficient strength. Your agent
will have testing equipment to do the necessary tests and recommend
steps for improving signal strength if required.
Copyright InFocus Trading 111 cc, 2009
To Next Page
Loading...
Need help?
General