VoiceAlert User Manual
1 Introduction
Please read the VoiceAlert System 6 Operating Instructions pamphlet
included in the VA6000S starter kit before continuing in order to
understand the basic radio operating principle behind VoiceAlert System 6.
Please note: ‘Sensor’ will be used as a generic term for any device used
for triggering Zones on the VoiceAlert Base Receiver.
1.1 VA6000S Starter Kit
Figure 1: VoiceAlert Base Receiver and PIR Sensor
The VA6000S starter kit forms the basis of the VoiceAlert system. It
consists of Base Receiver (VA-rx) and one VA6000T PIR Sensor (VA-tx)
(Figure 1).
You will seldom use the starter kit on its own unless you only need to
monitor a single Zone. Most applications require more than one Sensor.
Please contact your WirelessAlert agent if you wish to purchase additional
Sensors.
1.2 Power requirements
Base Receiver requires 12Volts to operate (e.g. 12V JUS transformer
power supply supplied in the starter kit).
Sensor requires a standard 9V battery (gives average six months
operation), 11.7V Long Life Battery (LLB) or 9V rechargeable battery.
1.3 Features
Basic features are listed in the VoiceAlert System 6 Operating
Instructions pamphlet (please read this before continuing).
1.4 Accessories
In addition to extra V6000T Sensors (VA-tx) (Figure 2), a Mini Transmitter
module (m-TX) (Figure 3), is also available for operation with the Base
Receiver. The m-TX module allows for a range of 3
rd
Party detection
devices (Infrared PIR, point-to-point beam, pressure mat, vibration switch,
and or tripwire) to be wirelessly coupled with the Base Receiver. Other
accessories include 433 MHz signal repeaters and a range of high gain
antennas for improving Sensor signal transmission and reception.
Operation of these accessories is not covered in this manual. Please
contact your WirelessAlert agent for further information.
Copyright InFocus Trading 111 cc, 2009
To Next Page
Loading...
Need help?
General