2
Contents
Introduction Page
Dear customer 2
Do’s and don’t’s 2
Things you should know Page
1.1 Gas appliance 3
1.2 Electrical supply 3
1.3 Explanation of controls 3
1.3.1 Mode selector switch... 3
1.4 Explanation of features 3
1.4.1 Frost protection mode 3
1.4.2 Automatic temperature control 3
1.4.3 Anti seize function 3
1.4.4 Appliance status indicators 3
1.5 Guarantee registration card 3
Getting started Page
2.1 Before switching on 3
2.2 Appliance controls 3
2.3 Lighting the boiler 3
How to... Page
3.1 Use the appliance for the 1
st
time 4
3.2 Use the mode selector switch 4
3.3 Re-pressuring the system 4
3.4 Shut down the system for short periods 4
3.5 Shut down the system for long periods 4
3.6 Care for the appliance 4
What if... Page
4.1 I suspect a gas leak 5
4.2 I frequently have to top-up the system 5
4.3 The fault light is on 5
4.4 The appliance is due its annual service 5
4.5 I need to call an engineer 5
Vokera timeclock (accessory) Page
5.1 Vokera timeclock 6
Dear Customer
Your Mynute EHE boiler has been designed to meet and exceed the very latest standards in gas central heating technology and if cared
for, will give years of reliable use and efficiency. Your Mynute EHE is a System boiler that provides heated water to radiators and/or a hot
water cylinder. Features included are LED indicators showing the status of the appliance and system pressure gauge, frost protection
and anti-pump seize function. Please therefore take some time to read these instructions carefully.
Do’s and don’t’s
● Do ensure that the system pressure is periodically checked
● Do ensure that you know how to isolate the appliance in an emergency
● Do ensure that you are familiar with the appliance controls
● Do ensure that your installer has completed the appliance log book
● Do not attempt to remove the appliance casing or gain internal access
● Do not hang clothes etc. over the appliance
● Do not operate on sealed components
● Do not forget to have the appliance serviced annually.
INTRODUCTION
Fig. 1
1= Pressure gauge
2= Mode selector switch
3= Fault indicator led
4= Temperature selector
5= Timeclock aperture (optional)
12345
To Next Page
Loading...
