To Next PageTo Next PageWhy does my Volt Polska Inverter show 'Overload' and beep?
The “Overload” symbol appears, or “Overload” LED is ON, and the UPS is beeping because the UPS is overloaded. To resolve this, remove the non-critical load.
What to do if Volt Polska Inverter shows 'Error' and beeps (not due to overload)?
If the “Error” symbol appears, or the “Overload” LED is ON (not due to overload), and the UPS is beeping, it could be due to several reasons: * The UPS is overheating: Remove the non-critical load. * Ventilation holes are blocked: Clean the ventilation holes. * Ambient temperature is too high: Cut off the output and input, and wait for at least 30 minutes, then restart it. * Load is short circuit: Remove load and restart the UPS, if it’s still not ok, contact the dealer/ manufacturer * Cooling fan is dead: Replace it.
Why does my Volt Polska Inverter have short backup time?
A short backup time on your Volt Polska Inverter can occur due to: 1. Short charging time: Charge battery at least 10 hours. 2. Faulty battery: Replace the battery.
How to fix Volt Polska Inverter that won't turn on with mains power?
If your Volt Polska Inverter won’t turn on when there is mains power, it might be because the press time is too short. Press and hold the power switch until the UPS gives a beeping sound. If that doesn't work, contact the dealer / manufacturer.
What to do if my Volt Polska Inverter won't charge the battery?
If your Volt Polska Inverter isn’t charging the battery, the issue might be: * Faulty battery: Replace the battery. * Faulty charger: Contact the dealer / manufacturer.
General| Apparent power | 900 VA |
|---|---|
| Rated power | 630 W |
| Input voltage (DC) | 12 V |
| Input voltage (AC) | 230 V |
| Output voltage | 230 V |
| Output frequency | 50 Hz |
| Waveform | Pure Sine Wave |
| Efficiency | 90% |
| Protection | Overload, Short circuit, Over temperature, Low battery |
| Cooling | Fan |
