OPERATING INSTRUCTIONS 15
The battery pack must be charged prior to the first startup.
1. Press the push lock button and remove the
battery from the device.
3. Plug the charger into the power supply. The charging status is displayed by the charger indicators.
4. Insert the battery pack into the device and make sure it clicks into place correctly.
-Check all parts for a firm, tight fit.
-Check whether there are visible defects: broken parts, cracks, etc.
-Check the rear hand guard for damage.
-Check the switch-on safety lock and start button to ensure they are functioning correctly
-Check whether all handles are free from oil.
-Check the chain catcher for damage.
-Check the device for correct chain tensioning.
-Check the chain brake to ensure it is functioning correctly.
● Press the push button for battery indicator.
● The remaining battery capacity is indicated by the 4 LED lights. Battery capacity indicator is shown below:
LEDs on the Battery
All 4 LEDs are lit. The battery is fully charged.
1,2 or 3 LED (s)are lit. The battery has adequate remaining power.
1 LED blinks. The battery is empty. Please recharge the battery.
All LEDs blink. The battery pack is too hot (e. g. due to direct sunshine or
prolonged use) or too cold (below32°F/0°C). ln this condition, do not
use or charge the battery pack. Make sure the battery temperature is
between 40F (4°C) and 104°F(40°C).
Battery Status
2. Insert the battery pack into the charger.
Checking the Remaining Capacity of the Battery
Check Before Starting
DANGER! Risk of injury! This device must only be used if no faults are found. If any part of this defective, it
must be replaced before the next use. Check the safety equipment and the working condition of the device.
To Next Page
Loading...