c) Persons and Equipment
• Do not exceed the maximum capacity of the scale. Refer to the “Technical Data”
section for further information.
• The scale must be secured to a connection that can withstand loads greater than
the maximum capacity of the scale.
• While under load, prevent jolts, twisting, swinging, vibrations, and horizontal
forces.
• Only raise loads onto the scale in a vertical direction.
• Before loading the scale, visually inspect hanging/load receiving elements/devices
for damage and wear. Do not use if any damage or wear is found!
• Do not leave loads hanging from the scale for extended periods of time. This can
damage the measuring equipment and/or any connected devices.
• Avoid shock loading the scale. Sudden and jerky acceleration or deceleration of
attached loads can cause breakage.
• Make sure there are no persons or objects underneath elevated loads. This can
result in serious bodily harm if the load drops.
• The scale is not designed to weigh extremely hot substances (e.g. molten iron,
boiling water) or burning substances. Serious harm can be caused in the event
of an accident.
d) (Rechargeable) Batteries
• Correct polarity must be observed while inserting the (rechargeable) battery.
• The (rechargeable) batteries should be removed from the device if it is not used
for a long period of time to avoid damage through leaking. Leaking or damaged
(rechargeable) batteries might cause acid burns when in contact with skin, there-
fore use suitable protective gloves to handle corrupted (rechargeable) batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (re-
chargeable) batteries lying around, as there is risk, that children or pets swallow
them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and
new (rechargeable) batteries in the device can lead to (rechargeable) battery
leakage and device damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into
re. Never recharge nonrechargeable batteries. There is a risk of explosion!
Operating Elements
1
2
3
4
5
6
1 Carabiner
2 LCD display
3 Button controls: on/off-tare, unit, hold
4 Hook
5 Battery compartment cover
6 Battery compartment
Insert Batteries
• Remove the battery compartment cover (5).
• Insert 2 x AA batteries into the battery compartment (6) matching polarities as shown inside
the compartment.
• Replace the battery compartment cover (5).
Replace batteries when the low battery indicator shows.
Operation
Overload Warning! When the LCD shows “O-Ld” remove any attached load to avoid
damage to the load cell, scale, and to prevent injury.
a) Weighing
• Hang the scale with hook (4) attached.
• Press the on/off (3) button to turn the power on.
• When the display (2) shows “0.0”, hang the load to be weighed over the hook (4) and wait
for the reading to stabilize.
• Press and hold the on/off button to turn the power off.
To preserve battery life, the scale will automatically power off after 120 seconds.
Operating Instructions
Hanging Scale
Item No. 2176564 (HS-300)
Item No. 2178480 (HS-100)
Intended Use
The product is a digital hanging scale with large back lit LCD display. It is designed to weigh
vertically raised loads. It is powered by two AA type 1.5 V batteries and has tare, hold, and unit
selection functions.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged. In
addition, improper use can result in other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery Content
• Hanging scale
• 2x 1.5 V AA battery
• Carabiner
• Hook
• Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General Information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dan-
gerous playing material for children.
• Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, ammable gases, steam and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Consult an expert when in doubt about the operation, safety or connection of the
appliance.
• There are no user-serviceable parts inside the device. Maintenance, modications
and repairs must only be completed by a technician or an authorised repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Connected Devices
• Also observe the safety and operating instructions of any other devices which are
connected to the product e.g. lifting arm.
To Next Page
Loading...
