Need help?Do you have a question about the Volvo Penta D13 MP and is the answer not in the manual?
General| Cylinders | 6 |
|---|---|
| Engine Type | Inline 6-cylinder |
| Displacement | 12.8 L |
| Bore | 131 mm |
| Stroke | 158 mm |
| Aspiration | Turbocharged |
| Emission Compliance | EU Stage V |
| Cooling System | Freshwater cooling |
| Fuel System | Common rail fuel injection |
Explains safety symbols and text priority for safe operation.
Covers new boat handling, daily checks, maneuvering, and accident prevention.
Details on safe fuel filling and starting procedures.
Addresses carbon monoxide poisoning and essential safety equipment.
Information on the limited warranty and owner's duties.
Commitment to environmental protection and initial engine operation.
Advice on fuel, oils, coolants, and service policies.
Specific requirements for emission-certified engines.
Ignition lock, e-Key panel, key management, safety lanyard.
Describes control panels, information panel, settings, and fault messages.
Station panel, low speed, neutral button, single lever, and gauge descriptions.
Covers 4" display, view selection, My View, and general system settings.
Describes the low speed function for hydraulic transmissions.
Discusses the function and installation of a propeller shaft brake.
Pre-start checks for engine, fuel, and oil levels.
Procedures for starting using ignition switch or starter button.
Guidelines for warming up the engine after starting.
How to read instruments and acknowledge alarms.
Shifting between forward and reverse, and planing.
Managing and switching between helm stations.
Optimizing speed for fuel economy and synchronizing twin engines.
Steps for stopping the engine using key or button.
Using auxiliary stop and post-shutdown checks.
Measures to take in cold weather to prevent damage.
Responding to system alarms and messages.
Identifying symptoms and possible causes of engine malfunctions.
Detailed descriptions of messages and suggested actions.
Situations where safety functions engage to protect the engine.
Procedure for jump-starting with auxiliary batteries.
Warranty inspection and extended service intervals.
Explanation of service codes (FSI, S1-S3, A, B, C, D, E).
Table detailing maintenance items and intervals.
General checks, oil, fuel systems, filters, levels.
Freshwater, seawater systems, coolant, impeller, filters, anodes.
Electrical system, batteries, connections.
Maintenance for reverse gears.
General instructions for inhibiting the boat for storage.
Specific steps for conserving lubrication, fuel, and seawater systems.
Procedures for preparing the boat after storage.
Mode, background, EVC settings, beeps, camera settings.
How to access and navigate the settings menu.
My View, display contrast, side selection, units, language.
Fuel tank calibration and speed factor.
Engine type, power, dimensions, reverse gear details.
Oil, fuel, cooling system data, water quality.
System voltage, generator, battery capacity.
Location and details of engine and transmission type plates.
To Next Page