Power Trim Assistant
51283a
The power trim assistant (PTA) adjusts the trim angle
automatically according to engine speed (RPM). PTA
will not move the drive if it is manually trimmed
above 7°.
The PTA is turned on and off in the SETTINGS menu
or in the main menu level if the option has been
selected for viewing at that level.
It is possible to change the power trim assistant default
settings by performing a power trim calibration. For
additional information, please see PTA (On/Off) in the
section entitled EVC Menu.
NOTICE! If the boat is equipped with Power Trim
Assistant, the function must be turned off before taking
the boat out of the water. This prevents automatic
trimming of the drive(s) if any test runs are performed
while the boat is on land.
Instruments and Controls
52 47701898 12-2010
To Next Page
Loading...
