Emergency Trimming
51810
51813
If a fault occurs which prevents the drive from being
trimmed with the power trim control panel, it is possible
to perform an emergency trimming.
You may do so by holding the trim up/out button on the
remote control (A or 10) for over 5 seconds. The sys-
tem will display a message informing you that you may
override power trim limits. Continuing to hold the trim
up/out button may raise the drive beyond the limits set
by the boat manufacturer. The system will display a
message informing you that trim override has been
activated. You may continue raising the drive until you
have reached the mechanical limit.
NOTICE! If your transom shield/drive package is not
mechanically limited, when applying power trim over-
ride mode, use extreme caution while raising the drive
as there is a possibility of pushing the drive into the
swim platform.
NOTICE! Do not run engine above idle speed when
overriding trim limits set by your boat manufacturer as
it will cause damage to the U-Joint and engine.
NOTICE! If the power trim function does not work, the
trim gauges may not work either. Before starting an
emergency trimming, check the trim angle of the
drive(s) visually.
Instruments and Controls
47701898 12-2010 53
To Next Page
Loading...
