Volvo 2001 - External Components and Electrical Assembly

19 . Install the sea-water pump and the cooling water
pipes .
20 . Install the injectors and the return fuel pipe . Tightening
torque for the injectors 20
Nm (2,0 kpm) (14 .7 ft .lbs .) . Also
install the exhaust elbow and the water pipe between the
thermostat housing and the
exhaust elbow .
21 . Fit the valve coverusing a new gasket . Make sure that
the round hole for the crankcase ventilation is in the right
position . Fit the decompression device lever . Fit the
pressure pipes between the injectors and the injection pumps .
Also refit the inlet air silencer .
22 . Install the starter motor, the alternator and the
alternator
V-belt . Also install the electrical distribution box and
hook-up the
cable harness .