24
Hydraulics
Slew and offset movements
combination
Slewing movement is controlled by the left hand control
lever and offset movement is controlled by an electro-
proportional roller located on the right hand control lever.
The offset control indicator switch lights up after being
pressed on the left hand control switch. Offset mode is
switched on when the machine starts up. More cab floor
space due to no need for a floor pedal to control offset
movement.
Customer Benefit
More productivity.
More operator comfort. 001
•
•
Fingertip control
The accessory circuit and the boom offset are controlled
by an on / off switch located on the right joystick. A control
light on the instrument panel indicates which mode is
activated. Fingertip control is precise and smooth.
Customer Benefit
More operator comfort.
More productivity. 015
•
•
Fingertip control
The accessory circuit and the boom offset are controlled
by an electroproportional, roller-type control located on
the right joystick. A control light on the instrument panel
indicates which mode is activated. Fingertip control is
precise and smooth.
Customer Benefit
At any time the operator can accurately adjust the amount
and direction of flow with the fingertip control.
More productivity.
More operator comfort.
016
•
•
•
To Next Page
Loading...