Controls
Hydraulic controls 67
4
Circle shift lever
This lever is the fifth lever in from the extreme right. It controls the
circle shift function.
n Push forward on the circle shift lever to move the circle and
moldboard assembly to the left.
n Pull back on the lever to move the assembly to the right.
5
Front wheel lean lever
This lever is the third lever in from the extreme right. It controls the
lean of the front wheels to the left or right for a reduced turning ra-
dius and improved machine stability while grading.
n Push forward on the wheel lean lever to lean the front wheels
to the left.
n Pull back on the lever to lean the wheels to the right.
To Next Page
