Controls
68 Hydraulic controls
7
Control lever for scarifier, ripper or windrow elimi-
nator
This lever is the second lever in from the extreme right. The at-
tachments lever normally controls the scarifier function. The lever
also controls either a ripper or windrow eliminator if the grader is
not equipped with a scarifier.
n Push forward on the control lever to lower the attachment.
n Pull back on the lever to raise the attachment.
8
Articulation lever
This lever is located fourth from the extreme right. The articulation
lever controls the direction of the articulation function.
NOTE! Remove the articulation lock pins before attempting to
articulate the grader.
n Push forward on the control lever to articulate the grader to the
left.
n Pull back on the lever to articulate the grader to the right.
n The indicator gauge in the pedestal displays the amount of
frame articulation.
Refer to Steering using articulation page 93.
WARNING!
Do not articulate the grader when operating on steep
slopes or when roading the machine. Grader could roll
over. Severe personal injury or death could result. Always
articulate the grader prior to moving onto the slope.
To Next Page
