The front section of the driver's seat can be adjusted to seven different height settings and the rear
section can be adjusted to nine different height settings.
Lever A = adjustment of front section
Lever B = adjustment of rear section
WARNING!
Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be
depressed fully. In addition, position the seat as far rearward as comfort and control allow. The seat
rails on the floor must not be obstructed in any way when the seat is moved.
2 Forward-rearward seat adjustment
Pull the control upward, then slide the seat forward or rearward to the desired position. Make sure that
the seat is properly secured when you release the control.
3 Lumbar support
Use this control to adjust softer or firmer lumbar support.
4 Backrest tilt
Rotate the control to tilt the backrest rearward and or forward.
Folding front seat
The seat backrest can be folded down to the horizontal position for carrying long loads. To fold down
the backrest:
file:///K|/ownersdocs/2001/2001_SV40/01sv40_03b.htm (2 of 10)12/30/2006 3:49:16 PM
To Next Page
Loading...
Need help?
General
