GAIN MODES
POLYPHRASE supports three gain configurations that make it useful with different
audio sources. By default, the pedal is in “instrument level” mode. If your input signal
is clipping or if you hear too much noise, try adjusting the mode by following the steps
below. The pedal will always remember the most recently used mode (even between
power cycles).
Note: The “line level” mode will still clip when using particularly loud audio sources. If
you hear any clipping, you should turn down the signal going to the pedal. Although,
there is no harm in clipping the pedal if that sounds good to you!
To Next Page
Loading...