VonShef 2000165 - Initial Setup and Plate Handling; Preparation Before First Use; Fitting and Removing Plates

To Next Page

To Previous Page

A5P | 01

BEFORE FIRST USE

FITTING & REMOVING PLATES

• Carefully unpack the 3 in 1 Snack Maker and

remove all packaging materials including any

stickers or labels.

• Clean the

PLATES using a damp cloth or sponge

and mild detergent. Wipe dry with a soft dry

cloth.

• Clean the

MAIN UNIT of the appliance with a

damp cloth or sponge.

WARNING! Never immerse the MAIN UNIT in

water or any other liquid.

• Position the Snack Maker on a dry, level and

heat-resistant surface.

NOTE: When using the Snack Maker for the

first time, it may emit slight smoke or odour

whilst any production residue burns off. This

is completely normal and should disappear

after a few minutes. However, as it may affect

the flavour of your first batch made, it is

recommended that you pre-heat the appliance,

switch off and allow to cool.

• For best results, lightly coat the

PLATES with a

little cooking oil or cooking spray.

•

Select your desired PLATES to be fitted.

•

Align the lip on one side of the

PLATE with the black hinges of the Snack Maker and firmly push down

until it clicks into place.

IMPORTANT: Ensure BOTH PLATES are correctly fitted before switching on the appliance. DO NOT mix

PLATES.

•T

o remove the

PLATES, simply press the corresponding PLATE RELEASE BUTTON located next to the

HANDLE LOCKING CLIP and the bottom section of the MAIN UNIT.

WARNING! Always allow the PLATES to completely cool before removing them from the MAIN UNIT.