Voodoo Lab Control switcher User Manual

Here’s how to select between the two momentary modes:
1.) Apply power while holding down button #3. LED #3 will flash until you release
the button.
2.) Press button #3 to select the mode.
Momentary Mode LED #3
Pulse ON/OFF OFF
Pulse ON only ON
3.) Remove power when finished.
Set MIDI Channel
MIDI program change and control change messages include a channel number,
1 through 16. Control Switcher will only respond to messages received on its
specified channel.
The default MIDI channel is 1.
Note: When Control Switcher is being controlled by a Voodoo Lab Commander
or Ground Control Pro, its MIDI channel is ignored.
Here’s how you set the MIDI channel:
1.) Apply power while holding down button #2. LED #2 will flash until you release
the button.
2.) Find your desired MIDI channel from the table and press each button to
match.
MIDI
Channel
LED #1 LED #2 LED #3 LED #4
1 OFF OFF OFF OFF
2 ON OFF OFF OFF
3 OFF ON OFF OFF
4 ON ON OFF OFF
5 OFF OFF ON OFF
6 ON OFF ON OFF
7 OFF ON ON OFF
8 ON ON ON OFF
9 OFF OFF OFF ON
10 ON OFF OFF ON
11 OFF ON OFF ON
12 ON ON OFF ON
13 OFF OFF ON ON
14 ON OFF ON ON
15 OFF ON ON ON
16 ON ON ON ON

Voodoo Lab Control switcher Specifications

General

Brand	Voodoo Lab
Model	Control switcher
Category	Musical Instrument
Language	English