Zircon Master S En 230V v11 5
1. INTRODUCTION
Thank you for having purchased the ZIRCON MASTER S
furnace which, we are sure will all meet all your needs
and will satisfy your high demands.
This furnace has been designed according to the
requirements of latest industrial standards and we
guarantee that you will use it many years as your closest
assistant.
However, inappropriate use may damage the equipment
and be harmful to personnel. Please observe the relevant
safety instructions and read the Operating Instructions
carefully.
We wish you pleasant and fruitful work with the ZIRCON
MASTER S.
SYMBOLS USED:
In this furnace 50 free user programs are implemented.
Each program has 4 rising and 2 cooling stages. In
addition, there is a programmed parameter OPEN TIME,
which gives extra control of the final cooling.
Programs 00 and 01 are embedded and cannot be edited.
The name of program 00 is CALIBRAT and it is devoted to
temperature calibration. Temperature calibration is
performed using special calibration rings that have a
precise shrinkage for specific degrees.
Program 01 is called CLEAN and is designed to clean the
camera and heaters.
The other 48 programs are free and can be modified by
the user.
When sintering materials that require rapid cooling at
60°C/min, the parameters of the respective program are
adjusted to be:
COOL1RATE = 60
COOL1 TEMP = 1300
COOL1 TIME = 0
COOL2RATE = MAX
COOL2 TEMP = 1280
COOL2 TIME = 0
OPEN TIME = FCOOL
This symbol indicates that there is high
dangerous tension under the bonnet which it is put on
Switch off the furnace before removing the marked cover.
Symbol for HOT SURFACE;
ATTENTION: HOT SURFACE! DO NOT TOUCH!
This symbol indicates that the
machine complies with the requirements of the
Directives for Low Tension and Electromagnetic
Compatibility as well as for the Standards harmonized
with them.
To Next Page
