Zircon Master S En 230V v11 9
CONNECTIONS
Ensure that the mains voltage is ~230VAC and
the outlet has a protective ground.
Connect the furnace in a separate circuitry of
power supply with cable cross-section is at least
2,5 mm
2
.
The protective fuse of the circuitry should be
20A (if it is a fusible wire), or D25A (C25A) if it is
an automatic fuse.
Plug the power cord into the mains. Do not use
a power strip.
Place the machine in such a way that it can be
easily switched on and off both the mains switch
and the socket.
To Next Page
