vosfeel MT-210 - Page 14

a. paired status: red light flash 3s and then switch to constant light state
b. unpaired status: white light in constant light state
5. Lighting effect and alarm
5.1 Indicator Light
Status
Charging
Nr
1
2
3
1
2
3
4
5
Anti-fall
detection alarm
Out of trouble alarm
Low Battery
Power Adaptor
Charging abnormal
9
10
11
12
13
The robot is floating, please move to the ground
Get out of trouble failure, please move to an open area.
Battery is too low,
Charging voltage is abnormal, please replace the adapter
Please make sure that the robot is turned on and charged
with the 19V 0.6A adapter.
Cause of issue
Driven wheel
abnormal
Side brush
abnormal
Motor fan
abnormal
Beeps
1 bip
3 times
2 bips
3 times
2 bips
3 times
3 bips
3 times
4 bips
3 times
5 bips
3 times
6 bips
3 times
3 bips
3 times
APP
Error code
1
2
3
APP Error prompts and solutions
The wheel is entangled and clean the driving wheel. The
driving wheel is abnormal. Please check whether the driving.
The side brush is abnormal, please check if the side
brush is entangled, and clean the side brush.
The motor fan is abnormal. Please clean the garbage
and air ducting the dust box.
Finished Charging
Low Battery
Before starting network pairing
Network pairing process/WiFi connection lost
Connect to Wi-Fi
AUTO Display Status
white light in breathing state
white light in breathing state
Glows a continuous RED
white light in flashing state
white light in constant light state
5.2 Alarm tips
When the robot fails, the robot indicator flashes red and a beeping sound of varying
lengths is emitted. Refer to the following table to query the cause of the failure:
If the trouble cannot be eliminated according to the above operation, Please try the
following operations Re-open the power switch on the side of the robot and restart the
robot.
Red Light Glows a continuous RED (APP alarm prompt only applies to vosfeel MT-210)
Red light flashes