Standby mode: “ICE” indicator blinks;
Cleaning condition：“ICE” indicator blinks
quicker；
Working condition: “ICE” indicator lights
solidly.
“ICE FULL” indicator lights up when the
ice basket is full.
“ADD WATER” indicator lights up when
the water reservoir is lack of water.
BEFORE FIRST USE
1. Unpack the appliance, then check and make sure that all the accessories including ice
basket and ice scoop etc. are complete. Please contact the client service department if some
accessories are missing.
2. Please follow the operation as below to install the handle well in position.
1) Grasp both sides of the handle shown in arrows with hands and pull them outwards (see
Fig.1).
2) Make the handle align with the holes at the housing and release the hands, then insert the
handle into the holes of housing (see Fig.2).
3) Pull and make the handle be upright, and then pull both sides of the handle outwards by
following the operation of Step 1). Check and make sure that the handle is positioned well
at the holes of housing.
4) Hold the center of handle and lift it upwards (see Fig.3), check and make sure that no
abnormal condition can be found.
Start or stop the appliance；
To Next Page
Loading...
Need help?
General