EasyManuals Logo

VOX electronics EM-2100 User Manual

VOX electronics EM-2100
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
3. Make sure the ice maker is level and on a stable table or platform as to avoid
malfunction.
4. The incline angle of the ice maker cabinet should not exceed 45°during transportation
or use. Do not turn the ice maker upside down. Doing so could cause the compressor or
refrigerating system to operate incorrectly. Please allow time for the fluids in the
compressor to settle after the ice maker is moved or transported. Before using the ice maker
for the first time, please wait for 2 hours after the unit has been leveled and positioned in the
proper place.
5. The appliance must be placed on a dry and level surface with sufficient ventilation, far
from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch (15cm)
clearance on all sides of the ice maker for proper ventilation.
6. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to
fill the water reservoir with water of room temperature or lower.
7. Do not use the appliance in a very cold environment (lower than 5℃).
8. Clean the appliance before use by following instructions CLEANING AND
MAINTENANCE.
USING YOUR ICE MAKER
1. Ensure that the drain plug at the bottom of the water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the ICE indicator blinks.
NOTE: Allow the ice maker to rest for 30 minutes before plugging if it has been moved.
3. Open the top lid and remove the ice basket.
Fig.1
Fig.2 Fig.3
Fig.3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VOX electronics EM-2100 and is the answer not in the manual?

VOX electronics EM-2100 Specifications

General IconGeneral
BrandVOX electronics
ModelEM-2100
CategoryIce Maker
LanguageEnglish