Auto Power-Off Function (Only 230V version)
To comply with the European wide ErP regulation, this amplier has been tted with an automatic
power down function.
By default the function is engaged, and is designed to power down the amplier when a period 2
hours of no audio input is detected.
NOTES:
1. The Power switch is a momentary type. Momentarily move the switch up
for On and Down for Off. The switch will return to the centre position once
released.
2. The Auto Power-Off function can be disabled by moving the ECO switch to
the OFF position. The switch is located on the back panel next to the Mains
Inlet.
3. Power may not turn on or off if the switch is released in a very short time.
4. If the Gain or Volume is set to minimum, no input signal will be detected.
This will mean the auto power-off function will be enabled.
SPECIFICATION
AC10C1
• Controls: Gain, Bass, Treble, Reverb, Volume
• Input: 1 X Input Jack
• Output: 1 X External speaker jack
• Tube compliment: 2 x 12AX7, 2 x EL84
• Output Power: 10 W RMS (16Ω)
• Speaker: 1 x 10” VX10 (16Ω)
• Dimensions: 520 x 210 x 410 mm / 20.47 x 8.26 x 16.14 inches (W x D x H)
• Weight: 12.3 kg / 27.12 lbs.
• Accessory: Power Cable, Manual
*Specications and appearance are subject to change without notice for improvement.
To Next Page
Loading...
Need help?
General
