26
DELAY
This is a model of one of the most respected analogue tape echo machines ever made.
In the original the “echo” is produced by a playback head and the exact “delay time” is set
by varying the motor speed. Many professionals prefer these “lo-fi” units because of the
warm, dark echoes they produce.
HINT: In the CHORUS+DELAY combination effect, the FEEDBACK parameter is already
set to the optimal value.
WARNING! If you crank up the FEEDBACK too much, an uncontrollable, cascading “run-
away” of echoes will occur. So, use your ears and your common sense when setting this!
REVERB
A model of the most popular spring reverb system used in guitar amps.
HINT: In combination effects, the TIME and HI DAMP parameters are already set to opti-
mal values.
TAP “TIME” Sets the delay time in a range of 1...1486 [ms].
EDIT1 “MIX” Adjust the mix amount of the delayed sound.
EDIT2
[TAP+EDIT 1]
“TIME” This lets you use the knob to make fine adjustments
to the parameter.
EDIT3
[BYPASS+EDIT 1]
“FEEDBACK” Adjusts the amount of feedback.
TAP “TIME” Sets the reverb time in a range of 0.8...8 [seconds].
EDIT1 “MIX” Adjusts the mix amount of the reverb sound.
EDIT2
[TAP+EDIT 1]
“TIME” This lets you use the knob to adjust the reverb time.
EDIT3
[BYPASS+EDIT 1]
“HI DAMP” Adjusts the dampening of the high-frequency range.
To Next Page
Loading...
Need help?
General
