To Next Page

To Previous Page

➢ Check the settings of the GAIN, VOLUME, TREBLE, MIDDLE, and BASS con-

trols. On certain amp types, if the TREBLE, MIDDLE, and BASS controls are all

turned down, there will be little or no sound coming from the amp due to the way

the circuit of the original works.

➢ If you’re in Manual mode (the MANUAL LED lit), turn the following controls above

their minimum setting: GAIN, VOLUME, TREBLE, MIDDLE, and BASS.

4. There’s no sound heard from the LINE/PHONE jack when you use it.

➢ Check that the top panel MASTER volume isn’t turned all the way down.

➢ Make sure sound is coming from the amp. IMPORTANT NOTE: You’ll need to

unplug your headphones or cable from the LINE/PHONE jack to do this, since

plugging something into this jack automatically mutes the amp’s speakers. If

there’s still no sound from the amp, go to page 27 “There’s no sound coming from

the amp.” If you do hear sound, check the headphones or cable you are hooking

up to this jack.

5. You can’t hear any effects.

➢ Check that the BYPASS LED isn’t lit. If it is lit, the effect is bypassed. Press the

BYPASS button to disengage it; the BYPASS LED will go off.

➢ Is the EDIT 1 knob turned down too low? Adjust the EDIT 1 knob.

Questions and Answers:

Need help?

Do you have a question about the Vox AD15VT and is the answer not in the manual?

Vox AD15VT Specifications

General