5
Quick Start
nce you’ve satisfied your primal urge to play, I’d like to suggest you give this man-
ual a chance — it’s been written by a fellow guitar nut and this amp boasts some
killer bells ‘n’ whistles that will warrant your interest. In short, it’ll be worth your
while, we promise. This said, here’s the “Quick Start” — enjoy! I look forward to taking you
through the amp in more detail once you’re done...
HINT:
If you’re not sure of the location of a control or switch referred to in this Quick Start
section, you can refer to the illustrations in the section entitled “The Guitarist’s Guided
Panel Tour” (page 7).
S
ETUP
1. Turn the MASTER volume control on the amp all the way down.
2. Plug one end of the supplied power cord into the AC power connector on
the rear panel, and plug the other end into a wall outlet.
3. Plug your guitar into the INPUT jack on the top panel.
4. Turn on the POWER switch.
5. Slowly raise the MASTER volume to a desired level.
C
HECKING
OUT
THE
PRESET
PROGRAMS
1. Press the top panel PRESET button.
The PRESET LED will light which means you’re in Preset mode.
2. Turn the STYLE selector switch to select a sound style.
For each sound style you select, a preset containing a typical sound for that type
will be automatically selected. The GAIN, VOLUME, TREBLE, MIDDLE, BASS,
and effect settings will be switched automatically.
S
WITCHING
BETWEEN
THE
CHANNELS
OF
A
PROGRAM
1. Press the top panel CH (Channel) button.
The CH1 or CH2 LED will light, and the program assigned to the corresponding
channel will be recalled (Channel Select mode).
2. CH1 and CH2 will alternate each time you press the CH button.
HINT:
You can store your favorite settings in each channel of the program. For details,
see “Storing your program” (page 15).
To Next Page
Loading...
Need help?
General
