To Next Page

To Previous Page

STORING A PROGRAM

When your tweaking has resulted in a sound you’re happy with, store it!

1. Press the WRITE button (3.6).

The name display (3.8) shows “✳WRITE✳,” and the bank display (3.1) and

CHANNEL SELECT 1–4 buttons (3.3) will blink.

2. Use value knob 3 (2.5) or the ▲, ▼ buttons (3.2) to select the bank you want to

use, and use the CHANNEL SELECT 1–4 buttons (3.3) to select the channel.

For example if you want to store your program in 13-1 (bank 13, channel 1),

you would use value knob 3 or the ▲, ▼ buttons to make the bank display (3.1)

show “13,” and then press CHANNEL SELECT button 1 to make the button

blink.

3. Press the WRITE button (3.6) again and you’re done!

The display will indicate “COMPLETE.” Your program is now stored, and you’ll

be back in Program Select Mode.

NOTE: The program is written over the previous contents of that bank/channel

location; in other words, the program in the number you selected in step 2 will be

erased.

NOTE: If you decide not to store your new program, just hit the TUNER/CANCEL

button (3.7) to abort this operation.

NOTE: If you’re tweaking your sound in Program Select Mode, your tweaks will be

lost if you switch to a different program (or to manual mode) or turn off the power

without storing.

If you’re tweaking your sound in Manual Mode, and switch to a different program or

turn off the power without storing, the settings you made in the effect section and

UTILITY parameters (e.g., noise reduction) will remember the values you set last;

the next time you enter Manual Mode, these settings will be recalled. The settings

of the amp section will reﬂect the current positions of the selectors and knobs.

RESTORING A SETTING TO ITS ORIGINAL VALUE

(Original Value)

The Original Value icon in the value display (3.10) gives you a way to ﬁnd out the

parameter values that are stored in a program.

When you are using a knob or button to change the value of a parameter, the

ORIG (Original Value) icon will appear when the value you are adjusting matches

the “original value” stored in the program.

HINT: So, you’re ﬂipping through the programs on your new ToneLab, and you

come across one you really like. It’s easy to ﬁnd out exactly what settings are

dialed in to get such an awesome tone – just use this original value display feature!

Vox E 1 User Manual

Questions and Answers: