50
the settings of the amp section are determined by the physical positions of the
selectors and controllers, they will not change.)
HINT: If ToneLab received all data, all data other than the amp section settings of
Manual Mode will be overwritten automatically. However if the data was received in
Program Select Mode, the data being edited (i.e., the edit buffer) will not be
changed.
Adjusting the Digital Output
Level
(GLOBAL “DOUT LVL”)
ere’s how to adjust the output volume of the DIGITAL OUT jack.
1. Press the GLOBAL button (3.5) to make the button light.
2. Press the 1/PREV or 2/NEXT button (3.3) to make the name display (3.8) read
“DOUT LVL.”
3. Adjust the digital output level from the DIGITAL OUT jack in a range of “–12”–
“12” (dB). “0” is the normal level. Use value knob 3 (2.5) or the ▲, ▼ buttons
(3.2) to make the desired setting.
NOTE: If you raise the level above “0” (dB), the digital output may distort for some
programs.
NOTE: The setting you change here is remembered automatically. When you have
finished making the setting, press the TUNER/CANCEL button (3.7) to return to the
mode you were in.
H
To Next Page
Loading...
Need help?
General
