TunerFoot
Controller
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
53
5. You can’t hear any MODULATION, DELAY or REVERB effects
even though they’re dialed in...
• Are the effect LEDs lit?
If an LED is dark, the corresponding effect is off. Press the TYPE button to
select an effect type.
• Could the modulation “DEPTH” or the delay/reverb “MIX” be set to a low value?
Press the TYPE button to select an effect and use the value knobs to adjust the
appropriate parameters.
• Could the effect be bypassed? Is the effect type LED blinking?
If so, press the TAP button to cancel bypass. The effect type LED will stop blink-
ing and remain lit.
6. You’re using the ACOUSTIC pedal effect and getting nasty
high frequency distortion.
• Could the Drive setting be excessively high?
• Are you using a very high output humbucking pickup?
Either turn down the volume of your guitar, or turn down the GAIN setting.
7. The sound connected to your guitar amp is distorted, or
sounds wrong.
• Could the AMP/LINE switch be set to “LINE”?
• Could LEVEL be raised excessively?
To Next Page
Loading...
Need help?
General
