EN -7-
• Install the plastic distance guide (the part with black vanes at the rear)
by turning it 90° as shown in the gure to prevent the condenser from
touching the wall.
• Refrigerator should be placed against a wall with a free distance not
exceeding 75 mm.
Before Using your Fridge
• When it is operated for the rst time or after transportation, keep your
fridge in the upright position for 3 hours and plug it on to allow efcient
operation. Otherwise, you may damage the compressor.
• Your fridge may have a smell when it is operated for the rst time; the smell will fade
away when your fridge starts to cool.
HOW TO OPERATE THE APPLIANCEPART 2.
Thermostat setting
• Thermostat automatically regulates the inside
temperature of the refrigerator compartment
and freezer compartment. By rotating the knob
from position 1 to 5, colder temperatures can be
obtained.
• The “ “ position shows thermostat is closed and no cooling is available.
• For short-term storage of food in the freezer compartment, you can set the knob between
minimum and medium position (1-3).
• For long-term storage of food in the freezer compartment, you can set knob medium
position.(3-4)
• Note that; the ambient temperature, temperature of the freshly stored food and how often
the door is opened, affects the temperature in the refrigerator and freezer compartments.
If required, change the temperature setting.
• When you rst switch on the appliance, you should ideally try to run it without any food
in for 24 hours and not open the door. If you need to use it straight away, try not to put
much food inside.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting
in order not to damage the compressor.
• The freezer of the refrigerator cools down to -18°C and less.
To Next Page
Loading...
Need help?
General