Vox StompLab IG User Manual

12
Troubleshooting
If you suspect a malfunction, please check the following points. If
this does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
 Have the baeries have run down?
When the baeries run low, the program/value display will
be dark. We recommend that you replace the baeries as
soon as possible. If baeries become unusable, remove them
immediately. Leaving drained baeries in the unit can cause
malfunctions (such as battery leakage). You should also
remove the baeries if you won’t be using the StompLab for
an extended period of time.
 Make sure the baeries are inserted with the polarities (+, -)
in the correct orientation.
 Is the AC adapter connected to the rear panel DC9V jack?
 Is the AC adapter plugged into an AC outlet?
 Could the AC adapter be damaged?
2. No sound
 Is the volume of your guitar turned down?
 Is your guitar cable connected correctly?
 Is your guitar cable broken?
 Are the [AMP/DR] VALUE 1 (GAIN) or VALUE 2 (LEVEL)
parameters currently set to a low value?
 Are the [Lo] or [Hi] parameters currently set to a low value?
For some amp models, there may be no sound from the amp
if the TREBLE, MIDDLE, and BASS control values are low.
 Is the volume turned down for another eect?
 Is the Mute function activated? Refer to “Bypass and Mute”
(p. 8) and cancel the Mute function.
 Is the master volume turned down?
Set the CATEGORY selector to [GBL], and turn the VALUE 2
knob to adjust the master volume.
3. Eects don’t apply
 Could an eect be o?
 Is the [MOD] VALUE 2 knob (DEPTH) or the [DLY] or [REV]
VALUE 2 knob (MIX) set to a low value?
 Is the StompLab in Bypass mode? Refer to “Bypass and Mute”
(p. 8) and cancel the Bypass function.
4. High frequencies are distorted when using [PDL] (PEDAL)
AC (ACOUSTIC)
 Are you applying too much drive? Lower the [AMP/DR]
VALUE 1 (GAIN) seing.
 Are you using a guitar that has high output humbucking
pickups? Lower the volume of your guitar.
5. Sound source connected to the guitar amp is distorted, or
sounds wrong
 Is the VALUE 1 knob (StompLab OUTPUT/PHONES jack
connection volume) in [GBL] set at Ln (LINE)?
Set to A1—A3 (AMP).
 Is the VALUE 2 knob (LEVEL) in [AMP/DR] or the VALUE 2
knob (MASTER LEVEL) in [GBL] set too high?

Vox StompLab IG Specifications

General

Brand	Vox
Model	StompLab IG
Category	Music Equipment
Language	English