EasyManuals Logo
Home>Vox>Music Equipment>StompLab IG

Vox StompLab IG User Manual

Vox StompLab IG
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
how far either has veered.
When in tune, both the Tuner center LED will light up.
Adjusting the tuner calibration
You can adjust the reference pitch of the internal tuner (piano
center frequency A). You can calibrate this reference pitch in a
range of 438Hz–445Hz.
When you turn o the power, the calibration adjustment that you
made will be discarded and the StompLab will automatically
be set to 440Hz.
1. Change the reference pitch with the or buon. when the
tuner is starting up.
The program/value display will indicate a reference pitch
(38–45: 438–445Hz).
Creating your sound (Edit mode)
The Edit mode is where you can set the eects that are used
in each category, such as [PDL] (PEDAL), [AMP/DR] (AMP/
DRIVE), [CAB] (CABINET), [NR] (NOISE REDUCTION), [MOD]
(MODULATION), [DLY] (DELAY) and [REV] (REVERB).
Signal ow
PEDAL
AMP/DRIVE (Lo - Hi)
REVERB
DELAY
MODULATION
NOISE REDUCTION
CABINET
Entering Edit mode
1. In Program select mode, press the EDIT buon. You will enter
the Edit mode and the EDIT LED will light up.
Selecting eects and adjusting the parameters - [PDL],
[AMP/DR], [CAB], [NR], [MOD], [DLY], [REV]
Select an eect to use in each category and set the parameter.
1. Select the category with the CATEGORY selector.
2. Select the eect with the or buon.
The program/value display will indicate an abbreviation of the
eect name and the Tuner
LED will light up.
For the eects and parameters that you can select, please refer
to the “Appendices” section on page 50.
When you select an eect, the StompLab automatically sets the
parameters of that eect to the most eective values.
By adjusting the parameters, you can tweak your sound to
what you have in mind.
To turn an eect on/o, press both the and buons
simultaneously. When an eect is on, the eect name is
shown, and when an eect is o, the display indicates “oF”.
3. Set the eect parameter with the VALUE 1 knob and VALUE
2 knob.
As you turn a knob, the program/value display will indicate
the values. For VALUE 1 the Tuner center LED will light up
and for VALUE 2 the Tuner # LED will light up.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vox StompLab IG and is the answer not in the manual?

Vox StompLab IG Specifications

General IconGeneral
BrandVox
ModelStompLab IG
CategoryMusic Equipment
LanguageEnglish

Related product manuals