Vox StompLab IG User Manual

5
([AMP/DRIVE]) gain. When making this adjustment, the program/
value display will indicate the gain value and the EDIT LED and
Tuner center LED will blink.
In Edit mode, use this knob to set the rst parameter of an eect.
Also, when saving a program, use this knob to select the program
location where a set program will be saved (wrien).
3. VALUE 2 knob
In Program select mode, use this knob to adjust the amplier
([AMP/DRIVE]) output level. When making this adjustment, the
program/value display will indicate the output level and the EDIT
LED and Tuner # LED will blink.
In Edit mode, use this knob to set the second parameter of an eect.
4. EDIT button, EDIT LED
Use this buon to switch the Program select mode and the Edit
mode. The modes can be switched each time the buon is pressed.
When in the Edit mode, the EDIT LED will light up.
In Program select mode, the Value lock function turns on when
this buon is pressed and held for 2 seconds and the functionality
of the VALUE 1 and VALUE 2 knobs will be disabled. The Value
lock function is canceled when the buon is pressed and held
again for 2 seconds.
The Value lock function can only be enabled in Program select
mode.
5. Program/Value display
In Program select mode, this indicates the selected program number
and the knob value. When BYPASS/MUTE is active, the display
indicates the name of the note that you’re tuning.
In Edit mode, this indicates the eect abbreviations, parameter
values. Also, this indicates the program number that was selected
as the save location when the program is saved.
6. ,  buttons
In Program select mode, use these to select programs. The program
number will increase (decrease) each time you press the buon.
In Edit mode, use these buons to select an eect and turn it on/
o. Use them to select the program in the save location and execute
the save function when saving a program.
Also, the calibration is set when the tuner is started.
7. Tuner LED
In Program select mode, this serves as the tuner meter when
BYPASS/MUTE function is active.
In Edit mode:
• The le

LED will light up when the eect name is indicated
in the program/value display.
• The center LED will light up when the VALUE 1 knob value is
indicated in the program/value display.
• The right
# LED will light up when the VALUE 2 knob value is
indicated in the program/value display.
8. Program UP/DOWN pedals
In Program select mode, use these pedals to select programs.
The program number will increase (decrease) each time you
press the pedal.
In Edit mode, use these to switch the display of the program/value
display. The display is switched in the order of “Eect Name”
↔“VALUE 1 Value” ↔ “VALUE 2 Value”.

Vox StompLab IG Specifications

General

Brand	Vox
Model	StompLab IG
Category	Music Equipment
Language	English