S70
75
ENGLISH
OPERATIONS
Setting Hot Loops, Loops must be created using the main loop interface (LOOP IN/OUT button. Once a loop is
created, following the setting process.
Step 1 : Press the desired pad from the BANK pads (1, 2, 3, 4)
19
at the point you wish to set as a hot-cue point
or a loop in that pad. You can overwrite any existed Hot-cue.
Step 2 : Press the stored Hot-cue pads again, and playback will seamlessly restart from the stored Hot-cue point
and the pad will fl ash. You can repeatedly press the pads to create a stuttering effect. If the player is in
pause or cue mode, pressing the button will start playback from the stored cue point, but will only keep
playing while the button is depressed, just like the main CUE button
14
.
•
Clearing the stored Hot-Cues/Loops
Press the SHIFT button to active clear memory function. While the button is on, press the BANK pad(s) you wish
to clear and those pads will also fl ash. The cleared pads’ light is off, letting you know that there is no information
stored in them.
How to Record Hot Cues/Loops
Every track can be record 4 cue points or loops. For the external USB device, the numbers depended on the
available memory space of the USB device. In general, the saved data size is very small so you don’t worry about
the quantity.
To save current cue points, loops, and setting, press and hold the LOOP ROLL button
18
until the display reads
Saving.
Rcall saved Hot cues/ Loops
First of all, you have to press the HOLD button
24
to active the Recall function. Rotating the TRACK/FOLDER serch
knob
5
to choose the music. If the music had saved Hot Cues/Loops, the player will recall the saved automately.
The VFD display will display “RECALL”. The pads will fl ash one after another. When the last pad has reloaded, then
you can press a BANK pad
19
to recall a cue point or loop.
CAUTION
: Do not power off the unit right after saving. You must wait at least 3 seconds in order for the
new presets / cue points to be stored in memory.
To Next Page
Loading...