7
Telephone settings
Analog Corded 1-line/2-line Petite Phone - A2211/A2221
Analog Corded 2-line Trimstyle Phone - A2321
Default settings are indicated by asterisks (*).
Setting Options Adjustable by:
Handset earpiece volume
(for models A2211 and A2221 only)
1, 2*, 3, 4 User and administrator
Handset earpiece volume
(for model A2321 only)
1, 2, 3*, 4, 5 User and administrator
Ringer volume Low, Medium*, High User and administrator
Ringer tone Tone 1*, Tone 2, Tone 3 Administrator only
Flash
(for model A2221 only)
1 (100ms), 2 (300ms), 3* (600ms) Administrator only
Voicemail voltage detection Disable voicemail voltage detection,
Periodic low voltage pulse detection method,
Steady high voltage and periodic high voltage
pulse detection method
Administrator only
Ringer tone
There are 3 ringer tone options. For 2-line models A2221 and A2321, changing the ringer tone of either LINE 1 or LINE 2 applies to
both phone lines.
To change the ringer tone:
Turn the telephone base over with the bottom side facing up. Remove the mounting bracket if it is in desktop position. To remove
the mounting bracket, rmly push both tabs downward and pull up until they release from the grooves.
Slide the ringer tone switch to select the desired detented position using a narrow object such as a standard screwdriver.
Install the mounting bracket accordingly.
Flash
For 2-line model A2221, there are 3 ash duration options that can be programmed.
To change the ash duration:
Remove the faceplate and overlay if they are on the telephone base. Lift the handset, then press the recessed PROGRAM key.
The MUTE key ashes when in administrator mode.
Press FLASH and you hear 3 beeps. Then press a dialing key, 1 (100ms), 2 (300ms) or 3 (600ms), to select the desired ash
duration. Press the recessed PROGRAM key again. You hear 3 rising beeps as conrmation.
1.
2.
3.
1.
2.
Telephone settings
To Next Page
Loading...
Need help?
General