SET UP THE BABY MONITOR
2.3 Parent unit installation
The package comes with two rechargeable batteries. You can power
up the parent unit by using two rechargeable batteries or by connecting
it to the mains power. However, even if the parent unit is connected to
the mains power, we recommend you to also install the rechargeble
batteries. This guarantees the continual operation in case of a power
outage.
To set up the parent unit:
Remove the battery compartment cover.
Install the supplied rechargeable batteries into the battery
compartment, matching the polarity markings (+ and -).
Replace the battery compartment cover.
Insert the DC plug of the other power adapter into the DC socket on
the side of the parent unit.
Connect the other end of the power adapter to a suitable mains
power socket.
The Charging LED lights up indicating the parent unit is charging.
1.
2.
3.
4.
5.
6.
To Next Page
Loading...
Need help?
General
