Troubleshooting (continued)
Common cure for electronic equipment.
If the video and audio monitor is not responding normally, try the
following (in the order listed):
1. Disconnect the power to the baby unit and the parent units.
2. Remove the battery packs in the parent units and then install
again.
3. Wait a few minutes before connecting power back to the baby
unit and the parent units.
4. The baby unit and the parent units should turn on when they are
powered up.
5. Wait for the parent units to synchronize with the baby unit. Allow
up to one minute for this to take place.
•
To Next Page
Loading...
