Frequency control Crystal controlled PLL synthesizer
Transmit frequency
Baby unit: 2407.5 - 2475 MHz
Parent unit: 2407.5 - 2475 MHz
Maximum power used by the transmitter: 0.1W (100mW)
Channels 32
LCD 2.8” Colour LCD
(QVGA 320x240 pixel)
Nominal effective range Actual operating range may vary according to environmental conditions at the time of use.
Power requirements
Parent unit: 3.6V, 2600mAh, 9.36Wh Li-ion battery
Parent unit power adaptor:Output: 5V DC @ 1A
Baby unit power adaptor:Output: 5V DC @ 600mA
Technical information
• Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors or
fluorescent lamps).
• DO NOT expose it to direct sunlight or moisture.
• Avoid dropping the product or treating it roughly.
• Clean with a soft cloth.
• DO NOT immerse the parent unit and the baby unit in water and do not clean them under the tap.
• DO NOT use cleaning spray or liquid cleaners.
• Make sure the parent unit and the baby unit are dry before you connect them to the mains again.
General product care
To keep this product working well and looking good, follow these guidelines:
Storage
When you are not going to use the HD video monitor for some time, store the parent unit, the baby unit and
the adapters in a cool and dry place.
To Next Page
Loading...
Need help?
General
