The types of screws and anchors you need depend on the composition of the wall.
Drill two holes in the wall ( 7/23 inch drill bit ). If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on the
ends with a hammer until the wall anchors are flush with the wall.
Wall-Mount (Optional) - BM3450N | BM3450N-2
Items to purchase
You will need to purchase the following items separately to mount your baby unit:
2 screws
2 anchors
Check for reception strength and camera angle before drilling the holes.
Use a pencil to mark two holes in parallel. Make sure they are the same distance apart as the wall mount holes
on the baby unit.
To Next Page
Loading...
