VTech CS6319 User Manual

4
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on page 40 for battery
operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The handset beeps and shows LOW BATTERY. If you are on
a call in low battery mode, the handset beeps every minute.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge
and the handset cannot
be used.
Charge without interruption
until the screen shows
LOW BATTERY (at least 10
minutes).
The screen shows
PLACE IN CHARGER
and ƀCUJGU
Battery has very little
charge and the handset
cannot be used.
Charge without interruption
until the screen shows LOW
BATTERY (at least four
minutes).
The screen shows
LOW BATTERY,
ƀCUJGUCPFVJG
handset beeps.
Battery has enough
charge to be used for a
short time.
Charge without interruption
until the screen shows
HANDSET X (about one hour).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.

VTech CS6319 Specifications

General

Type	Cordless Phone
Number of Handsets	1
Frequency	DECT 6.0
Caller ID	Yes
Call Waiting	Yes
Phonebook Capacity	50
Talk Time	Up to 10 hours
Standby Time	Up to 5 days
Speakerphone	Yes
Display	LCD
Ringer Volume Control	Yes
Answering System	No
Keypad	Yes
Wall Mountable	Yes
Power Source	AC Adapter
Battery Type	NiMH
Features	Intercom, Mute, Volume Control
Range	Up to 1000 feet
Expandable	Expandable up to 5 handsets

Summary

Getting Started

Parts Checklist

Lists all items included in the VTech telephone package.

Installation and Setup

Instructions for installing the telephone base, charger, and handset.

Handset and Base Layout

Overview of handset buttons and telephone base features and indicators.

Telephone Settings

Ringer and Audio Settings

Adjust handset ringer volume, tone, key tone, and speaker volume.

Display and System Settings

Configure LCD language, date/time, and clear voicemail indicators.

Dialing and Home Area Code

Set dial mode and program home area code for call logging.

Answering System Management

Answering System Configuration

Set number of rings, remote code, and message alert tone.

Announcement Customization

Steps to play, record, or delete custom greetings for the answering system.

Message Playback and Memos

Play, delete, or manage recorded messages and memos.

Telephone Operations

Basic Call Handling

How to make, answer, end calls, and use speakerphone.

Advanced Call Features

Using mute, ringer mute, call waiting, find handset, and intercom.

Directory Management

Storing, searching, editing, and deleting contacts in the phone directory.

Call Log and Redial

Managing call history, saving entries, and using the redial list.

Caller ID Information

Understanding Caller ID service and its display features.

Answering System Operations

System Overview and Setup

Understanding answering system and voicemail features, and message capacity.

Answering System Control

Turning the system on/off, call screening, call intercept, and base ringer volume.

Message Handling and Remote Access

Playing messages, managing memos, and accessing the system remotely.

Appendix: Support and Safety

Troubleshooting Common Issues

Solutions for problems like no dial tone, battery issues, or interference.

Important Safety Instructions

Essential safety precautions for using the telephone equipment.

Warranty and Specifications

Product warranty details, service information, and technical specifications.

Regulatory Compliance

Information on FCC, ACTA, and Industry Canada regulations.