EN - 11
English
Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
• Plug the Cat-5 network cable into the
RJ-45 LAN port on the telephone base
and the network wall jack with Power
over Ethernet (PoE).
1 Network wall jack with Power over
Ethernet (PoE)
2 Cat-5 network cable
3 RJ-45 LAN port
2. Once installed, the telephone begins an
initialization and system registration process.
If the system registration succeeds, the
telephone base will reboot.
If the system registration fails, the
key blinks twice every second. To reset,
disconnect the Cat-5 network cable
from the network wall jack with Power
over Ethernet (PoE) and then reconnect.
3. Press on the telephone base. Listen for a
dial tone, and then press again to hang
up.
Note
• The dial tone will not be played if the SIP
account used by this phone cannot be
registered.
Use only the supplied network cable. The
supplied network cable is not designed for
use in any other IT devices. Misusing it on
your other IT devices shall be prohibited.
To order a replacement, call 1-888-907-2007.
1
2
3
To Next Page
Loading...
Need help?
General
